MARIMEX Orlando Premium 10310019, Руководство по сборке

Страница: 101 / 144

101
the substrate so that it can not be moved without damage. Make sure that the ar-
ched seam remains approximately in the middle of the fillet (see Figures 4-15).
After smoothing the floor, continue swimming the pool and gradually smooth the foil
on the wall. Ensure that the foil is not tightened and that there is no air gap.
Gradually remove the plastic clamping strips at the top of the wall, always just one
piece and smooth the wrinkles on the foil. On the smoothed part, put the plastic
clamping strips in close-up (Figures 4-18).
After all the wrinkles have been wiped off, cut off the overlapping portion of the last
plastic bar so that its end is tightly seated on the following bar (Figure 4-19).
FOR CIRCULAR POOL: Now press the plastic bar [4] on the clamping bar. Use a pair
of flexible coupling pins [2] to connect another plastic strip [4] and follow the entire
circumference of the pool. (see Fig.
4-20). To shorten the last plastic strip, connect it to the rest of the upper frame using
a pair of connecting pins (see Figure 4-20).
NOTE: The supplied coupling pins [2] are in two guides - the pins without longitudinal
cut are designed for the lower frame, the longitudinal section pins (elastic) for the
upper frame.
NOTE: The slight ripple of the foil during installation is natural. It is caused by the will
of the vinyl material, which protects the film when it shrinks.
NOTE: The film is not a structural element of the pool. Its main function is to prevent
water from leaking out of the pool. The water pressure is held by the walls and the
construction elements of the pool. The film must adhere properly to the ground, the
filler filler and the pool wall, never carry the weight of water that could damage it.
Part 5 – Installation of upper bars and collars at the
oval pool
Identify upper leaves
The 3,7x5,5m oval pool consists of 4 6-A strips and 6 bars 6.
Continue to fill the swimming pool
a. Continue filling your pool with water while installing the top frame and the vertical
pillars of the pool.
Remove written collections and upper leaves
Attach the metal plate [17] to the upper end of the column with the inclined strut [9]
of the oval pool and the wall [30]. Align the holes in the plate and the post with one
another and screw both parts together with a pair of self-tapping screws [3] (Figure
5-2).
On the metal plate [17], slide the upper rails from both sides (Fig 5-3) according to
the type of oval pool (Fig 5-3).
Apply and align the bottom of one vertical post [1] in the round part of the pool with
the retaining part of one connector [2] (Figures 5-4). The connector tab of the co-
nnector must be outside the vertical post.
Align the bolt hole in the post and the bolt hole in the flap and attach the column
with the self-tapping screw [3] (Figures 5-4).
Place the upper clutch [4] on the top edge of the pool wall so that the flap of the
upper clutch catch part is outside the pool (Figure 5-5).
EN