100
EN
for this visible part of the joint. After installing the wall and measuring the circulari-
ty of the pool, be sure to remove the center pin.
AID: We recommend using the assembled pool stairs to climb and enter the pool.
Check whether the wall of swimming pool water in
water treatment plants
• Use a tensioned string with a suspended level (Figure 4-10) to check if the op-
posed upper edges of the pool wall are in one plane. Check the wall in several
different directions. The wall must stand on a horizontal plane. If the deviation
from the horizontal is more than 25 mm in length of the pool diameter (Figures
4-11), then put the wall aside and re-align the pool base to the horizontal.
WARNING: A non-horizontal pool is dangerous and may collapse.
Create cut float
Use a slashed sand to form a rounded filler panel about 20 cm wide and 20 cm high
at the bottom of the wall across the entire perimeter of the pool. Shape the curve
and firmly snap its shape (Figures 4-12).
IMPORTANT: For an oval pool - In the place of a pillar with an oblique strut on the
oval pool, the size of the fillet should be adjusted as shown in Figure 4-13. At the
same time, make sure that the heel plate is covered with about 2 cm of compacted
sand. The heel profile must not protrude from the floor surface.
Now smooth the surface of the floor. Take care of smooth surface transitions.
Lay the bottom of the pool on the bottom of the geotextile to protect the pool
against mechanical damage. Install the pool pad as soon as you've assembled the
pool wall and made an inside fillet of shredded sand. Unpack the base at the bo-
ttom of the pool, center and align any storages. A few centimeters above the filler
pad cut off the pad. Take care not to get stones or other sharp objects on top of the
mat (Figure 4-131 - A = fillet filler, B = washer)
Follow the foil on its place
NOTE: If you will use the filtration equipment together with the pool, it will be ne-
cessary to perform a part of the installation of the surface dirt collector before in-
stalling the film. Please read and follow the instructions for installing the collector.
Open the cardboard box. Do not use anything sharp to open the box.
Unpack and unfold the foil and spread it in the sun to warm it up. Check the entire
foil surface and all seams if they are not leaking.
Spread the foil in the pool so that the seams face up. The arched seam is to be in
the middle of the fillet fillet fillet. The other seams will form lines across the bo-
ttom of the pool (Figures 4-14 and 4-15).
Smooth the wrinkles of the foil at the bottom of the pool.
Save the foil on its place
Drag the foil over the edge of the pool wall and secure it securely with a few plastic
clamps (Figures 4-16). Leave the foil for free. Do not turn the foil too much.
Start swimming pool with water. As the pool fills up, smooth out all the wrinkles
on the foil to smooth out the center of the pool in circles towards the wall. You can
help with a soft brush. Never push the foil over too much force and do not pull on
it. Proceed quickly because a few centimeters of water can press the foil against
Содержание Orlando Premium 10310019
