DSM800 User’s Manual
Page 12
Revision 1.0
The first time you start the DSM800, you must ensure that the device can connect to your LAN (local
area network). The DSM800 comes from the factory preconfigured to obtain its LAN connection
information from a DHCP (Dynamic Host Control Protocol) server. If your local area network uses a
DHCP server, no configuration is necessary, and the DSM800 should be able to successfully connect
to the local area network.
2.5.1 Manually Entering LAN Connection Information
If your local area network does not use DHCP, you must manually enter the LAN connection
information into the DSM800. This is done through the following steps:
Figure 12 – N2KView
®
Window with Tabs Displayed
a.
Click anywhere inside the N2KView
®
screen to display the screen tabs as shown in Figure 12
above.
b.
Click on the “
Configuration
” tab on the right side of the N2KView
®
screen to display the
Configuration dialog.
