®
®
2.4.4 Power Sequencing
When the DSM800 is connected to an appropriate power source, you can use the power switch
located on the back panel (see Figure 8) to turn the DSM800 on or off. If the DSM800 is turned on,
then the LED found on the front panel will be illuminated blue. If the power switch is pushed to power
down the DSM800, the LED will be illuminated yellow.
The DSM800 can also be switched on and off by applying or removing power through an external
switch or breaker. Anytime the power is reapplied to the DSM800, it will turn on.
2.5
Configuring the DSM800
In order to use the DSM800, you must already have N2KServer
®
installed and running on either a
Windows PC or on a Maretron IPG100 Internet Protocol Gateway.
You must also have some information as to the configuration of your local area network.
The DSM800 will start up with the following warning screen:
Figure 11 – DSM800 Startup Screen
You are required to press
Accept
and thereby acknowledge this warning message before N2KView
®
will run in Live Mode.
Revision 1.0
Page 11
Alternatively, you may
Enter Demo Mode
. In Demo Mode, you will not be able to connect to a Server
and view live data; instead simulated data will be provided to stimulate the controls.
