Marathon V-4830, Руководство по эксплуатации, техническому обслуживанию и установке

Страница: 50 / 50

WARNING:
BEFORE START-UP, REPLACE THE 3/4” PLUG ON THE TOP OF THE
POWER UNIT RESERVOIR WITH THE FILLER BREATHER CAP. THIS CAP IS
SHIPPED INSIDE OF THE PANEL BOX.
DANGER:
DO NOT CLIMB ON SIDES OF BALER. USE A LADDER WHILE PER-
FORMING THE FOLLOWING PROCEDURES.
WARNING:
PARTS OF THE PLATEN WILL EXTEND ABOVE THE TOP OF THE
BALER WHEN THE PLATEN IS FULLY RAISED.
CAUTION:
MAKE SURE PERSONS AND MATERIAL ARE CLEAR OF CHARGE
BOX AREA.
1. After the electrical connections are complete, check motor rotation by the
following:
a. Close bale chamber door and feed gate.
b. Turn disconnect switch to the ON position.
c. Have someone turn ON the keyswitch and depress the AUTO-
CYCLE button for one second and then immediately depress the
EMERGENCY STOP button. Check motor rotation by watching the
hub coupling through the slot in the pump-to-motor adapter. There
is a rotation decal on the power unit showing correct rotation. In the
event that this decal is missing, look at the hub coupling from the
motor end. Rotation should be clockwise.
CAUTION: If the pump rotates backward, stop immediately!
The pump will be damaged if it is operated in reverse even for
short periods. Reversing any two incoming power lines will change
the motor/pump rotation.
2. With the platen fully raised, check to be sure the oil reservoir is filled to the 3/4
level on the sight gauge (Refer to the maintenance chart for hydraulic oil recom-
mendations). The hydraulic system pressure has been factory set.
3. The baler is equipped with an electrical interlock which prevents the use of
the AUTOCYCLE and MANUAL DOWN functions when the feed gate is in the up
position. If either of these buttons start the baler when the feed gate is up, dis-
continue use of the baler until repairs have been made.
4.
MAKE SURE THAT THE OPERATORS ARE TRAINED IN THE
PROPER USE OF THIS EQUIPMENT.
3 INSTALLATION
START-UP INSTRUCTIONS
3-4