Marathon V-4830, Руководство по эксплуатации, техническому обслуживанию и установке

Страница: 16 / 50

1 OPERATION
OPERATING INSTRUCTIONS -
BALE TIE OFF/BALE EJECT FOR V-6042LP
1-13
When the BALE MADE light comes on, it is time to tie off the bale and eject the bale
from the baler. See page 1-5 for control panel layout and location. See the following
page for a diagram of the following steps.
FOR BALE TIE OFF & BALE EJECT (V-6042LP):
1. Depress the MANUAL UP button until the feed gate opens.
2. Insert a large, flat piece of material across the top of the bale.
3. Close feed gate and depress the AUTOCYCLE button. The platen
will stop in the down position and the BALE MADE light will be illumi-
nated.
CAUTION
: CLEAR ALL PERSONNEL FROM FRONT OF BALER
BEFORE PROCEEDING WITH STEPS 4 THROUGH 8.
4. Release the bale chamber door latch on the side of baler and open
the bale chamber door all the way. Feed gate is closed but will raise
when chamber door is opened.
5.
CAUTION:
Wear safety glasses and leather gloves during the follow-
ing operation: Tie off bale by inserting bale ties through the platen,
“loop end” first. Always insert bale ties through the tie slots in the
platen, first. Feed wire through until it comes out of the slot in the
baler floor. Tie off each tie. Bale ties should be tightened only hand
tight, allowing for bale expansion when platen is released.
6. Depress the MANUAL UP button until the platen reaches its up posi-
tion.
7. Standing at the side, make sure all personnel are clear of the front of
the baler. Depress and hold the MANUAL UP button and hold the
RETRACT/EJECT switch to the right (EJECT) until the bale ejects.
Depress and hold the MANUAL UP button and hold the RETRACT/
EJECT switch to the left (RETRACT) until the ejector retracts all the
way. Baler will not function if ejector is not fully retracted.
8. Remove bale from in front of baler.
9. Close and latch the bale chamber door. Bale sequence is ready to be
repeated.
NOTE: You can close the feed gate at this time if added security is required. To
open the gate you will have to run the baler through a complete AUTOCYCLE.