Marathon V-4830, Руководство по эксплуатации, техническому обслуживанию и установке

Страница: 14 / 50

When the BALE MADE light comes on, it is time to tie off the bale and eject the bale
from the baler. See page 1-3 for control panel layout and location. See the following
page for a diagram of the following steps.
FOR BALE TIE OFF & BALE EJECT (V-6030LP):
1. Depress the MANUAL UP button until the feed gate opens.
2. Insert a large, flat piece of material across the top of the bale.
3. Close feed gate and depress the AUTOCYCLE button. The platen
will stop in the down position and the BALE MADE light will be illumi-
nated.
CAUTION: CLEAR ALL PERSONNEL FROM FRONT OF BALER
BEFORE PROCEEDING WITH STEPS 4 THROUGH 8
.
4. Release the bale chamber door latch on the side of baler and open
the bale chamber door all the way. Feed gate is closed but will raise
when the chamber door is opened.
5. CAUTION: Wear safety glasses and leather gloves during the follow-
ing operation:
Facing the front of the bale, tie off bale by inserting bale ties (loop
end first) through the platen.
Always insert bale ties through the
tie slots in the platen, first. Go to the rear of the baler and feed
the loop end of the bale ties down and through the aligned tie slots in
the floor. Finally, go to the front of the baler and tie each of the
ties. Bale ties should be tightened only hand tight, allowing for bale
expansion when released.
6. Before ejecting the bale, go to the rear of the baler and manually
engage the bale eject latch (WARNING: Never engage eject latch if
bale door is closed). To engage the latch, pull (rotate) the latch han-
dle up all the way. Standing at the side, make sure all personnel are
clear of the front of the baler. Depress the MANUAL UP button.
7. Hold the MANUAL UP button until bale ejects, then release button.
8. Remove bale.
9. Close and latch bale chamber door. Close feed gate. Depress AUTO-
CYCLE to cycle and reset ejector. Bale sequence is ready to be
repeated.
1 OPERATION
OPERATING INSTRUCTIONS -
BALE TIE OFF/BALE EJECT FOR V-6030LP
1-11