49
Surr.Parameter
Default settings are underlined.
Adjust surround sound parameters. It may not be possible to set this item depending on the input signal
(
“Surround modes and surround parameters”).
Setting items
Setting details
HT-EQ
Soften the treble range
of movie soundtracks for
better understanding.
ON
: “HT-EQ” is used.
OFF
: “HT-EQ” is not used.
This can also be set by pressing
HT-EQ
.
DRC
Compress dynamic range
(difference between loud
and soft sounds).
Auto
: Automatic dynamic range compression on/off control according to
source. This can be set in the Dolby TrueHD mode.
Low
/
Middle
/
High
: These set the compression level.
OFF
: Dynamic range compression always off.
D.Comp
Compress dynamic range
(difference between loud
and soft sounds).
OFF
: Turn dynamic range compression off.
Low
/
Middle
/
High
: These set the compression level.
LFE
Adjust the low-frequency
effects level (LFE).
–10dB – 0dB
For proper playback of the different sources, we recommend setting
to the values below.
• Dolby Digital sources : “0dB”
• DTS movie sources : “0dB”
• DTS music sources : “–10dB”
C.Image
Assign center channel
signal to front left and right
channels for wider sound.
0.0 – 1.0 (0.3)
Panorama
Assign front L/R signal also
to surround channels for
wider sound.
ON
: Set.
OFF
: Do not set.
Dimension
Shift sound image center
to front or rear to adjust
playback balance.
0 – 6 (3)
Audio Adjust
Setting items
Setting details
C.Width
Assign center channel
signal to front left and right
channels for wider sound.
0 – 7 (3)
Height Gain
Control the front height
channel volume.
Low
: Reduce the front height channel volume.
Middle
: Front height channel sound is output with standard sound
volume.
High
: Increase the front height channel volume.
NOTE
“Height Gain” is displayed for the following settings.
• When “Pre Assign” (
• When the “Speaker Config.” – “F.Height” setting (
) is set
other than to “None”.
• When surround mode is “PL
g
z” or the PL
g
z decoder is used.
Default
The “Surr.Parameter”
settings are returned to the
default settings.
Yes
: Reset to the defaults.
No
: Do not reset to the defaults.
When you select “Default” and press
ENTER
,
the “Return settings to the default?” prompt
is displayed. Select either “Yes” or “No”, and
press
ENTER
.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
A
dv
anced v
ersion
v
See overleaf
BD