89
Resetting the microprocessor
Perform this procedure if the display is abnormal or if operations cannot be performed.
When the microprocessor is reset, all the settings are reset to their default values.
RETURN
ENTER
ON/STANDBY
1
Turn off the power using
ON/STANDBY
.
2
Press
ON/STANDBY
while simultaneously pressing
ENTER
and
RETURN
.
3
Once the display starts flashing at intervals of about 1 second, release the two
buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
G
M-XPort
H
Symptom
Cause/Solution
Page
Audio is not output
when a wireless
receiver (RX101 is
connected).
• Check that the Bluetooth device and Wireless receiver (RX101)
are correctly paired.
G
Remote Control Unit
H
Symptom
Cause/Solution
Page
The set cannot be
operated with the
remote control unit.
• Batteries are worn out. Replace with new batteries.
• Operate the remote control unit within a distance of about
7 m from this unit and at an angle of within 30°.
• Remove any obstacle between this unit and the remote control
unit.
• Insert the batteries in the proper direction, checking the
q
and
w
marks.
• The set’s remote control sensor is exposed to strong light (direct
sunlight, inverter type fluorescent bulb light, etc.). Move the set
to a place in which the remote control sensor will not be exposed
to strong light.
• The operation mode does not match the settings of the device to
operate. Check the operation mode.
Basic v
ersion
A
dv
anced v
ersion
Inf
or
mation
Inf
or
mation
