18
17
1.
Using a paper clip tip, press the operation mode
button
q
until the NAME indicator appears and begins
to blink in the LCD window.
2.
Choose a button that you wish to re-name, in this case,
press the “LD” function button
o
3.
In the LCD window, the first character of the six
function character display indicators starts blinking.
4.
Choose the desired letter or number
by pressing the 10 keypad buttons
!2
. So, by pressing the 10 keypad
number 4 four times, you get the
letter “L” to appear in the display
(see Figure 4).
You use the cursor buttons
and
!6
to move to the next character
in the display. By pressing the right
cursor button
, the letter “L” is
confirmed in the first character
space in the LCD window and the
next character position begins blinking. If you wish to
erase a previously memorized character, position the
cursor over the character and put the SPACE
character in its place (the SPACE character is ten
keypad number 0 pressed four times, from the above
character chart).
5.
Continuing along, re-write the remaining letters “V”, “-”,
“5”, “2”, and “0”. By pressing the cursor keys
and
,
each character is confirmed in place. When you go to
other DIRECT function pages by using the page
function keys
i
, characters in the previous page are
also confirmed in place.
How to re-write the STATUS name:
6.
Using the same steps as outlined above, you can re-
write the 9-character status name. During step 5
above, by pressing the up and down cursor keys
!6
the left side of the status indicator begins blinking, and
you can change its display according to the same
method outlined above, using the 10 keypad character
generator. Remember, to confirm each character
change, use the cursor keys
and
. As above, when
you change the direct function page by pressing the
page direction keys
i
, this will confirm the re-written
characters in place as well for the page you just
finished re-naming. You have up to 9 letters, numbers
or other characters available for each status name.
How to re-write the DIRECT function button
names:
7.
You can change the name for each of the 8 direct
function buttons by using the steps described above to
change main function name and status name.
Remember, each main function has 8 direct function
buttons on each of the 4 pages, so you have up to 32
direct functions that can be re-named, if you wish, for
each of the 10 main function selection buttons
o
.
MACRO
MACRO
RC2000MK
LEARNING REMOTE CONTROL
POWER
ON
OFF
ON/OFF
CLONE
MACRO
MODE
SOURCE
Press the MODE button to switch to NAME.
Press LD.
DSS
MD
VCR
DVD
LD
TV
AMP
AUX
TAPE
CD
TUNER
OK
Press either key to move the
character entry position.
1
OSD
GUIDE MUTE
2
3
4
5
6
7
8
9
M
0
C
OK
Press “4” four times.
3
NAME
1
4
2
LOW
Figure 4
1
OSD
GUIDE MUTE
2
3
4
5
6
7
8
9
M
0
C
OK
Press
i
twice.
OK
Press to establish the entry. These
buttons are also used when
entering the status name or direct
mode name by moving the cursor.
LOW
Status name
Direct mode name
