20
19
You have up to four characters available for each
direct function button name.
8.
After completing all re-writing of any of the names,
press the
OK
button within the cursor keys
!6
.
9.
If, during re-naming, a button has not been pressed for
1 minute, the RC2000 Mk
w
will revert to the prior
operating mode automatically.
10.
If re-writing of all of the desired direct mode functions
has been completed, use the paper clip tip to press
the operation mode button
q
, and select the “USE”
mode. Now, all of the re-written names are available for
use.
Note:
The status and direct mode names of each page that are
not rewritten remain without being erased.
How to clear (erase) the memorized codes (and
any re-written names):
The RC2000 Mk
w
has a high capacity RAM, which
ordinarily will allow the learning of several hundred remote
codes (and their associated new names, if desired).
However, due to the fact that some remote codes occupy
more memory space than others, it is possible that the
available RAM fills up completely, and the “FULL” indicator
appears in the LCD window. In this case, it will not be
possible to learn any new remote codes without first
deleting some or all of the previously learned remote codes
and/or re-written names. There are 4 ways to erase learned
remote codes from memory:
Erasing by button(s)
Erasing by function(s)
Erasing by direct buttons (Pages)
Erasing all memory contents (complete erasure)
Note: The factory-programmed RC-5 codes are not
stored in RAM, and are therefore not erasable.
1.
For any of these memory erasure options, you must
first set the RC2000 Mk
w
to LEARN mode.
2.
Erasing the commands assigned to pages 1-4 of
each direct button:
Press and hold the “
CLEAR
” botton and press
or
button twice.
You will see “DIR CLR” indicated in the LCD window.
At that point, if you press “OK” in the cursor keys, you
will erase all four pages in that particular direct
function.
After clearing, the RC2000 Mk
w
will restore any
factory programmed codes.
If you do not wish to clear the pages, press any other
key other than the “
OK
” button.
3.
Erasing the memory assigned to a particular button:
First check the current function. (In this example, let us
assume that it is LD.)
Press and hold the “
CLEAR
” button
!4
and press the
button that you wish to erase 2 times.
The code previously learned by that button will be
erased, and will then be either empty, or the original
factory provided RC-5 codes will re-appear in its place.
DSS
MD
VCR
DVD
LD
TV
D4
D8
Press the page button.
To change the page
DSS
MD
VCR
DVD
LD
TV
AMP
AUX
TAPE
CD
TUNER
Press any of these buttons.
To change the function
MACRO
MACRO
RC2000MK
LEARNING REMOTE CONTROL
POWER
ON
OFF
ON/OFF
CLONE
MACRO
MODE
SOURCE
Press the MODE button to switch to USE.
POWER
ON
OFF
ON/OFF
CLONE
MACRO
MODE
SOURCE
Press the MODE button to switch to LEARN.
1
OSD
GUIDE MUTE
VOL
CH
AMP
AUX
TAPE
CD
TUNER
2
3
4
5
6
7
8
9
M
0
C
OK
While holding the CLEAR button depressed, press PLAY twice.
The LD PLAY code is cleared and the original RC-5 code is
recalled.
