10
9
D
Battery indicator
When the batteries are running low, this indicator will
become visible. At this point, it will not be possible to learn
any new remote codes, but normal remote control operation
is still provided (including the use of any previously learned
codes). At this point, you should consider changing the
batteries soon. As time goes on, and the battery power
diminishes further, this indicator will begin blinking. At this
point, no remote commands will be transmitted. This is your
signal to replace the batteries with fresh ones as soon as
possible. Eventually, if you ignore the blinking battery
indicator and do not install fresh batteries, then the
batteries may eventually be totally exhausted, and the LCD
display window will be completely blank. Even at this point,
and during the time when the batteries are removed for
replacement, any learned commands will remain in
memory, along with customized labels, macros, settings,
etc.
E
Transmit indicator
When a button is pressed, this indicator shows that an
infrared code is being transmitted.
F
USE indicator
For normal operation, the
USE
indicator should be visible.
G
LEARN indicator
Visible when the RC2000 Mk
w
is set to
LEARN
mode.
H
Indicator
Visible when the RC2000Mk
w
is set the beep function.
I
NAME indicator
Visible when the RC2000 Mk
w
is in the learning mode, and
function naming is being changed.
J
PAGE display
This shows the current page of each function.
When the macro function is activated, this display shows
the macro number.
Installing the batteries:
The battery compartment is located on the rear panel.
Please use only alkaline or lithium batteries, “AA” size. The
RC2000 Mk
w
requires four AA batteries. There are
markings in the battery compartment to show you the
proper battery orientation. If after installing the batteries,
you cannot see any indication in the LCD window when a
button is pressed, re-check to ensure that the batteries are
properly positioned in the compartment.
Loading batteries
The life of the batteries used with the remote control unit is
about 4 month with normal use. Also be sure to replace
batteries earlier when you notice that they are getting weak.
(1) Remove the back cover
(2) Insert batteries (AA type) with correct (+) and (-)
polarity
(3) Close the back until it clicks
Note:
Even when the batteries are removed for replacement,
the learned codes are held in memory.
Do not use old and new batteries together, for this may
lead to battery corrosion, and / or improper operation.
