Marabu StarLam 1600R, Руководство по эксплуатации и инструкция

Страница: 16 / 37

StarLam 1600R User Manual
15
10. When the heater box has reached the preset working conditions the working ready
light will illuminate indicating that lamination process may begin.
11. Gently lower the heating box down and onto the heater door stop guides.
12. Switch on the machine cooling fans. Adjust the motor drive speed to the
appropriate position. This starts the lamination process.
Upon laminating long rolled material:
•
According to the requirements of the lamination job be sure to pay close attention to
when more liquid laminate should be added to the liquid laminate reservoir.
•
The external diameter of the drive roller will continually increase along with the
process of liquid laminating. The linear speed may also increase as the diameter of roll
increases. Keep in mind to adjust the settings properly to decrease linear speed as
required thus insuring optimal lamination effect.
13. If an urgent situation arises and it is needed to stop the machine immediately
simply press down on the available emergency stop button located at the top and
on either side of the machine.
14. Once the liquid lamination process is finished switch off the motor speed switch,
the heater power switch and cooling fan switch.
▲
Do not switch off the main power supply switch if it is within 5 minutes after ending the
liquid lamination process. This can damage the heater if it is not allowed to cool properly
after being used.
15. Rotate the locking sleeve/jacket to the take up core roller (drive roller) so that the
core holder rod can be lifted up and out of the machine gently. The coated and
rolled material on the paper core can be removed at this point.
16.
Immediately clean the liquid metering rod, liquid trough to avoid drying and
hardening of the liquid laminate.
a. Loosen the metering rod retaining bolts on both side of the liquid
metering rod, and take it out and clean it immediately. For precise and
perfect cleaning use a pressure washer to remove built up coating and
any contaminates.
b. Remove fixed bolts on both sides of the liquid trough (this bolt is of a
special purpose during machine transportation and is not required to use
again once removed.