AVS S-SERIES INSTALLATION MANUAL - GEN 2 VER 5
36
Trouble shooting guide
Problem
Possible fix
No flash on arm/disarm or
Arms on lock/unlock button, disarms on boot button
Turn OFF Factory Remote Interface feature Register 1,
Feature 19
Arms/disarms off boot button
Turn OFF Register 2, Feature 2
Alarm chirps for 10 seconds on opening a door before
triggering
Turn OFF Register 1, Feature 21 (Keypad disarm mode,
not in manual).
No output on:
central locking
boot release
indicator flash etc
Polyfuse may have tripped. Check circuit for excessive
current draw or short. Polyfuse may take several
minutes before resetting. Wait and re-test.
Turbo timer problems
No engine shut down on boot button
Engine only runs for 10 seconds
Turn ON Register 1, Feature 17.
Register 1, Feature 16. Enter programming. Then after
turning ignition off, push the boot pop button again
(siren will beep) to set to 1 minute. Then turn key ON
then OFF to set.
No shock sensor
Turbo timer turned on. System will disable shock until
timer has timed out or
Shock sensor turned OFF. Register 2, Feature 3 to turn
back ON.
MAP upgrade problems
Upgrade loom does not work in enable or inhibit modes
In enable mode, nothing happens when I pulse the
motor wires
Turn on Register 1, Feature 14.
Make sure POS2 is getting a positive enable signal
when the motor wires pulse or constant.
Содержание AVS S Series
Страница 14: ...AVS S SERIES INSTALLATION MANUAL GEN 2 VER 5 14...
Страница 18: ...AVS S SERIES INSTALLATION MANUAL GEN 2 VER 5 18...
Страница 22: ...AVS S SERIES INSTALLATION MANUAL GEN 2 VER 5 22...