Manta AVS S Series, Руководство по установке

Страница: 11 / 36

AVS S-SERIES INSTALLATION MANUAL - GEN 2 VER 5
11
Data battery back-up siren wiring V2 (DBBSMV2)
The AVS data siren V2 has the following wires located on it:
Red: connect to +12V wire from alarm module bundled with other alarm wires, marked with red and white
sheathing.
Black: connect to GND wire from alarm module bundled with other alarm wires, marked with red and white
sheathing.
White: this is the siren trigger wire. It must connect to the SIREN wire from the alarm module. A maximum of two
data sirens can be connected to this wire. Note: As this is a data wire, no other type of siren can be connected to
it. The SIREN wire can be found with other alarm wires, marked with red and white sheathing.
Green: this wire gives a constant 200mA negative output (-ALARM) when the alarm is triggered. It can be used to
run additional piezo sirens or to activate the horn (additional relays may be needed). This is also useful f or
installations which require both a piezo siren and tilt sensor, as it allows the piezo to be activated via the –ALARM
wire from the siren, and the –ARM from the module can be used to activate the tilt upon arming. Note: Turning the
siren key off will also disable this wire output.
Brown: the bonnet wire is one length of wire looped within the siren. Connect the brown wire to the HOOD IN wire
from the alarm module bundled with the other siren wires in the red and white sheathing. Connect the black wire
coming from the siren labeled BONNET to the bonnet pin.