Manitowoc RFC0985, Инструкция по установке, использованию и уходу

Страница: 56 / 68

Maintenance Section 4
4-10
Part Number 000001196 3/08
19. Mix a solution of cleaner and warm water.
Depending upon the amount of mineral buildup, a
larger quantity of solution may be required. Use the
ratio in the table below to mix enough solution to
thoroughly clean all parts.
20. The cleaner solution will foam when it contacts lime
scale and mineral deposits; once the foaming stops
use a soft-bristle nylon brush, sponge or cloth (NOT
a wire brush) to carefully clean the parts. Soak parts
for 5 minutes (15 - 20 minutes for heavily scaled
parts). Rinse all components with clean water.
21. While components are soaking clean all foodzone
surfaces of the bin (or dispenser). Rinse all areas
thoroughly with clean water.
22. .Mix a solution of sanitizer and warm water.
23. Use 1/2 of the sanitizer/water solution to sanitize all
removed components. Use a cloth or sponge to
liberally apply the solution to all surfaces of the
removed parts or soak the removed parts in the
sanitizer/water solution. Do not rinse parts after
sanitizing.
24. Use 1/2 of the sanitizer/water solution to sanitize the
bin (or dispenser). Use a cloth or sponge to liberally
apply the solution. Do not rinse the sanitized areas.
25. Reinstall the removed parts, restore water and
power supply and test run the ice machine.
NOTE: Disconnecting the power supply will activate a 5
minute time delay before the ice machine will start. The
delay will start to time out when power is restored to the
ice machine. This delay period can not be over ridden.
!
Caution
Do not mix Cleaner and Sanitizer solutions together.
It is a violation of Federal law to use these solutions
in a manner inconsistent with their labeling.
Solution Type Water Mixed With
Cleaner 1 gal. (4 l) 16 oz (500 ml) cleaner
Solution Type Water Mixed With
Sanitizer 6 gal. (23 l) 4 oz (120 ml) sanitizer