Manitou B-E2 Series, Руководство оператора

Страница: 87 / 134

3 - 13
A3 - FUEL LEVEL
CHECK
Keep the fuel tank full, to reduce as much as possible any condensation due to the
atmospheric conditions.
- Open the side bonnet.
- Remove cap 1 (fig. A3).
- Fill the fuel tank with clean fuel (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL ), filtered
through a strainer or a clean, lint free cloth, through filler por t 2 (fig. A3).
- Put the cap back 1 (fig. A3).
- Check visually that there is no leakage in the tank and pipes.
Never smoke or approach with a flame during filling operations or when the tank is open.
Never refill while I.C. engine is running.
The fuel tank is degassed via the filler plug. When changing it, always use an original part, with degassing hole.
A4 - CYCLONIC PREFILTER
CLEAN
STANDARD MLT 523 Turbo Série B-E2
MLT 523 Turbo MONO-ULTRA Série B-E2
OPTION MT 523 Série B-E2
MT 523 MONO-ULTRA Série B-E2
MT 620 Série B-E2
The cleaning inter val is given as a guide, however the prefilter must be emptied as soon
as impurities reach the MAXI level on the tank.
- Loosen nut 1 (fig. A4), remove cover 2 (fig. A4) and empty the tank.
- Clean the prefilter unit with a clean dr y cloth and reassemble the unit.
When cleaning, take care not to let impurities into the dry air filter.
A5 - TYRES PRESSURE AND WHEEL NUTS TORQUE
CHECK
- Check the condition of the tyres, to detect cuts, protuberances, wear, etc.
- Check the torque load of the wheel nuts. Non compliance with this instruction can cause damage and rupture to the wheel bolts
and distor tion to the wheels.
Wheel nuts tightening torque
• Front tyres: 630 N.m ± 15 %
• Rear tyres: 630 N.m ± 15 %
- Check and adjust the tyre pressures if necessar y (see: 2 - DESCRIPTION: CHARACTERISTICS).
Check that the air hose is correctly connected to the tyre valve before inflating and keep all persons at a distance during inflation.
Respect the recommended tyre pressures given.
NOTE: There is an OPTIONAL wheel toolkit.
A6 - JIB PADS
CLEAN - GREASE
To be carried out ever y 10 hours during the first 50 hours ser vice, then once at 250 hours.
- Extend the jib completely.
- With a brush, apply a coat of grease (see: 3 - MAINTENANCE: LUBRICANTS AND FUEL) on
the 4 sides of the telescope(s) (fig. A67).
- Telescope the jib several times in order to spread the coat of grease evenly.
- Remove the surplus of grease.
If the lift truck is used in an abrasive environment (dust, sand, coal…) Use lubricating
varnish (MANITOU reference: 483536). In this respect, consult your dealer.
NOTE: A jib sealing kit is available as an OPTION. MLT 523 Turbo Série B-E2
MLT 523 Turbo MONO-ULTRA Série B-E2
A4
1
2
A6
A3
2
1