Mammuth SP50HEL, Инструкция по установке и эксплуатации

Страница: 15 / 25

3. Assembly
Transport
The units are generally too heavy to be moved by hand. Therefore, use the correct transport and
lifting equipment. The weights and dimensions of this machine (unit) are shown in the specifications.
During transportation, take all measures to prevent accidents caused by falling etc.. Also remove all
loose parts from the press. Only persons that are familiar with the risks/dangers and are qualified to
perform these tasks.
Unpacking
Remove the crate and check the shop press for damages, defect parts etc.. In case of any damages
caused by transportation or a defect part, immediately contact your Mammuth retailer.
Assembly
1. Remove the front of the crate, cut the straps, watch out for the strap when it comes loose.
You can now remove the front.
2. Now pull the plastic and then remove all loose parts from the press.
3. Remove the press out of the crate by means of a suitable lifting device, preferably a forklift.
4. Mount the legs under the press, mount the horizontal support (39) first and then the
diagonal supports (38). Place the bolts (34) from outside, then place a ring (35), spring
washer (36) and nut (37) on the bolt, tighten the nuts and bolts by hand. When the legs are
mounted on either side, carefully lower the press on the ground, but keep it supported with
the hoisting or lifting device. Check if the press stands level by means of a spirit level, then
tighten all nuts and bolts securely.
5. Then attach the pump (21) on the side of the press, this is best done with two people. The
one holds the pump and the other mounts the pump with the bolts (24) and rings (25).
6. Connect the pump (21) to the hydraulic cylinder (03) with the hydraulic pipes (19), note that
the O-rings (08) are in place.
7. Now mount the switch box (54) on the press with the bolts (17) and rings (16).
8. Now mount the mounting plate (H) for the winch (55) against the left side of the press with
the bolts (34), rings (35) spring washers (36) and nuts (37).
9. Then mount the winch (55) on the mounting plate (H) with the screws (52), rings (25), spring
washers (14) and nuts (53).
Placement of the shop press
When placing the workshop press, one needs to take into account a number of things, these are
listed below:
1. Keep sufficient free space around the press at least 1.5 meters from all sides, this because of
the to-and disposal of work pieces and in addition, this is also easy when one
maintenance/repair work to be performed.
2. Place the machine on a firm, flat and clean surface and set it properly fixed with anchor bolts.
3. The place of installation must be well ventilated, well lit and dry.
4. Never use the shop press near explosive and/or flammable substances and/or gases.