Mammuth SP50HEL, Инструкция по установке и эксплуатации

Страница: 16 / 25

1 2 3 4
5. Keep the place of installation clean. Humidity, dust and dirt have a negative impact on both
the working efficiency of the press and the lifetime of the press.
Connecting the powercord and plug
PLEASE NOTE! To do this, use only a power cable with a thickness of 2.5 mm² wire thickness with a
5-pole 16A plug, this must meet the latest requirements.
Step 1 (fig. 1): Take a 4-wire cable with a thickness of at least 2.5 mm², then strip the 4 wires.
Squeeze on blue cable shoes, on the 3 phase wires a V-shaped cable shoe and on the ground wire a
round cable shoe. If the cable has 5 wires, then cut the blue wire (0-wire) on both sides, the machine
is connected without zero (0)!
Step 2 (fig. 2): Connect the white 4-wire cable from the switch box that runs down to the pump
motor. Connect the 3 phase wires to U1, V1 and W1, connect the ground wire to the top at the
mark at the top of the Cabinet.
Step 3 (fig. 3): PAY ATTENTION! The plug must be 5-pole and 16A and it must comply with the
latest requirements.
The ground wire should be connected to the earth terminal of the plug (once again indicated by the
mark) and the 3 black wires should be connected to the 3 phase poles of the plug (usually
indicated with L1, L2 and L3). PLEASE NOTE! The machine does not use the zero (0) socket (usually
indicated by N).
Step 4 (fig. 4): First press the green button (fig. 1), then shut the switch box. Now turn the power
supply switch on the 1-position (ON). Now check the direction of rotation of the pump's right, do it
like this: control the press by the handle of the pump to the left to move, if the cylinder does not
come down, it means that the phase cables are connected incorrectly, in this case, you need to let go
of the handle immediately.
When you a have a plug with phase changer, you can exchange the
phases by using a flat head screwdriver and turning the phase changer (black disk with two poles in
Fig. 4) clockwise/counterclockwise. If you have a plug without phase changer you will need to open
the plug and change two of the phase wires. Now check again or the pump is properly connected by
above steps.