Mammoth J036HHC, Инструкции по установке, эксплуатации и обслуживанию

Страница: 3 / 13

Figure 1: Horizontal mounting detail (L009-J072H)
SEE GROMMET DETAIL
(SEE FIGURE 2)
Figure 2: Grommet detail
Figure 3: Typical vertical installation detail
HANGER RODS
（
BY OTHERS
）
MAX/MIN
DIVERGE
WATER OUT FPT CONNECTION
(SEE DIMENSIONAL DATA)
ACCESS TO COMPRESSOR
WATER COIL ， REVERSING VALVE
WATER IN FPT CONNECTION
(SEE DIMENSIONAL DATA)
7/8" O.D. COPPER
CO NDENSATE DRAIN
ELECTRICAL ACCESS
FLANGE ON FILTER GUIDE
FOR DUCT CONNECTION
FILTER LEFT OR RIGHT SIDE
REMOVAL
。
DUCTEO RETURN AIR
LIFT AND PULL ON NON-DUC
FLANGE ON FILTER GUIDE
FOR DUCT CONNEC TION
7/8"OR1-3/32"HOLE FOR LINE VOLTAGE
CONDUIT CONNECTION
（ SEE UNIT
SPECIFICATION SHEET FOR FURTHER DETAILS
）
NOTES
1
）
DOWN ACCESS FILTER GUIDES ARE ABLE AS OPTION
2
）
USE A BACKUP WRENCH ON FITTINGS WHEN MAKING WATER
CONNECTIONS
3
）
DO NOT SCREW DUCTWORK INTO THE HEAT PUMP CABINET USE
THE FLANGES PROVIDED ON FIL TER GUIDES AND BLOWER
OPENING
。
TOP PANEL
3/8”LOCKING NUT
THREADED ROD
(BY OTHERS)
ADJUSTABLE SLOT IN
HANGER BRACKET
WASHER
HANGER BRACKET
VIBRATION ISOLATION
GROMMET
WASHER(BY OTHERS)
MUST COVER ENTIRE
BOTTOM OF GROMMET
RETAINING NUTS
(BY OTHERS)
NOTES: NOTES: NOTES: NOTES:
1) AN INTERNAL BLOWER ACCESS
PANEL IS PROVIDED FOR
SERVICING UNIT. FULL SERVICE
PANELS ARE AVAILABLE ON ALL
SIDES.
2) THE ELECTRICAL CONTROL
PANEL IS LOCATED INSIDE THE
UNIT.
3) DO NOT SCREW DUCTWORK INTO
THE HEAT PUMP CABINET. USE
THE FLANGES PROVIDED ON THE
FILTER GUIDE AND THE BLOWER
OPENING.
4) USE A BACK-UP WRENCH ON
FITTINGS WHEN MAKING WATER
CONNECTIONS.
5) THE ELECTRICAL BOX CAN BE
MOUNTED ON THE OPPOSITE
SIDE OF THE CABINET.
6) THE SIDE DUCT CONNECTOR CAN
BE MOUNTED ON THE OPPOSITE
SIDE TO PROVIDE FILTER FROM
THE OTHER SIDE
TERMINAL STRIP
7/8 OR 1-3/32 DIA HOLE FOR
FILED CONDUIT CONNECTION
NECTION(SEE DIMENSIONAL DATA)
ELECTRICAL CONTROL
PANEL LOCATION
INTERNAL BLOWER
PANEL LOCATION
WATER OUT FPT CONNECTION
(SEE DIMENSIONAL DATA)
WATER IN FPT CONNECTION
(SEE DIMENSIONAL DATA)
SERVICE PANEL
7/8OD COPPER CONDENSATE
DRAIN 1” P-TRAP INTERNALLY
(INSTALLED AT FACTORY)
SERVICE PANEL
DISCHARGE AIR DUCT
CONNECTION