Mamiya M645 1000S, Инструкция по эксплуатации

Страница: 57 / 59

Troubleshooting
If your camera appears to be malfunctioning, check the
following list for a possible solution:
1. The Shutter Release Button will not move
A) Did you unlock the Shutter Release Button?
B) Did you wind the Film Advance Crank until it stops?
2. The mirror is locked in the up position
A) Did you release the shutter without a battery in the camera?
Check that a battery is installed in the camera body.
B) Was the battery correctly inserted into Battery Chamber?
Open the Battery Compartment Door and check the installation of the battery.
C) Is the battery the correct type for the camera?
Open the Battery Compartment Door and verify the type of battery.
D) Did you lower the Mirror Lock-up Lever?
Raise the Mirror Lock-up Lever.
E) Did you release the shutter with the Shutter Speed Dial set to ?
Move the Shutter Speed Dial to either B or 1/1000.
3. The developed roll of film has 1 or 2 frames lens than it should
A) Did you properly align the Start Marks with the Film Advance Crank after
placing the Roll Film insert into the camera?
B) Did you properly align the Start Marks and the Roll Film Insert?
4. The PD Prism Finder's LEDs do not illuminate when pressing the Meter Switch
A) Did you set the camera's Shutter Speed Dial to ? If not, there will be no electrical
connection between the camera and the finder.
5. You receive an electrical shock when using an electronic flash
Always keep the safety covers on the hotshoe and sync terminals when not in use.
54