Mamiya M645 1000S, Инструкция по эксплуатации

Страница: 43 / 59

Aperture Priority Method
If the Indicator Needle cannot be centered
even after turning the Aperture Ring as far
as it will go, the exposure must be adjusted
by turning the CdS Prism Finder's Shutter
Speed Dial. If the Indicator Needle is too
high, set the finder's Shutter Speed Dial to
a faster speed; if it is too low, set the finder's
Shutter Speed Dial to a slower speed. After
adjusting the exposure using the finder's
Shutter Speed Dial the Indicator Needle is
slightly off-center, make fine adjustments by
turning the Aperture Ring.
After adjusting exposures by turning the finder's
Shutter Speed Dial, be sure to set the camera's
Shutter Speed Dial to the same speed.
1. When desiring to set the aperture first, set the
Aperture Ring to the desired f/stop, and then adjust
the exposure by rotating the camera's Shutter Speed
Dial until the Indicator Needle is centered between
the two brackets.
2. Check the setting of finder's Shutter Speed Dial,
and then set the same speed as on the camera's
Shutter Speed Dial.
When adjusting exposures using the finder's
Shutter Speed Dial, do not use any intermediate
positions; always set the dial to a full click-stop
setting.
Exposure Compensation
The brackets in the viewfinder are notched at
+- 2 f/stops to simplify exposure compensation
for unusual lighting situations.
When the Exposure Meter Switch is set to OFF,
the Indicator Needle rests at the bottom position.
40