17
"Enable Slice Out lines" is the feather value option (set the value, the more the more
smooth), feather rate can reduce the model pixel pattern. The general value of 3 or
more, can effectively alleviate.
"Slice Thickness (mm)" setting range: 0.02-0.1mm.the default is 0.05mm, the smaller
the thickness is, the higher the accuracy will be, and more time the printing will need.
Exposure time can be reduced if the layer thickness is smaller.
“Exposure time (ms)”can be set according to the actual situation. Default 15 seconds,
print smaller and simple structure model can reach up to 3 seconds. If the details of
the print cannot be showed during the printing, then increase the single exposure time.
For some models with holes, the shorter curing time will be better. While for models
with smaller columns, the longer the curing time is, the better effect will be.
“Bottom exposure (ms)” default 60 seconds, when printing smaller and simple
structure model, it just need 5 seconds to stick to the platform in some cases.
Increase the exposure time if the model cannot stick to the platform. The longer the
exposure time is, the more tightly the base will stick.
"Z-axis lift distance (mm)" can beset according to the model size, if the area is too
large but the lifting height is low, the resin cannot be returned to the middle of the
model, resulting in bubble in the middle part, defect or print failure----just raise the