800-295-0042 ext 206
5
MPG460XT
2. Attach the spring hanger brackets to the frame. The U
shaped shackle bolt brackets mount to the front and the
C shaped “slipper” brackets mount to the rear as shown.
Use 3/8” x 1” bolts and nuts. Assemble with the nuts on
the inside of the
frame rails. Fully
tighten all 8 bolts
now.
3. Lay the two frame cross members
in between the frame rails. The
two holes in the middle should face
DOWN as shown. Channels face
each other.
4. Bolt the frame rails to the cross members
using 3/8” x 1” carriage bolts and nuts, (no
washers). The square carriage heads go to
the outside with the square holes in the frame
rails.
Leave the nuts loose until after all bolts are
installed. You will tighten everything at once in
a later step.
800-295-0042 ext.215
3. Lay the two frame cross members
in between the frame rails. The large
Malone decal should be in the rear,
facing upside down.
