Malone MPG460XT, Руководство пользователя

Страница: 21 / 37

MPG460XT
800-295-0042 ext 206
technical@maloneautoracks.com
20
2. Place the skid and chain
assembly under the tongue and
insert the bolt up through the
skid bolt hole on the bottom of
the tongue as shown.
3. Slip the ring terminal over
the bolt and install the nylon
lock nut hand tight.
4. Check that the rear end of
the skid is still in its hole in the
bottom of the tongue. Tighten
the bolt while holding the nut
stationary. This way the ring
terminal remains straight.
5. Install the
coupler and coupler
handle onto the
tongue as shown.
Then tighten until
the coupler fi rmly
grips the tongue.
Don’t over tighten
and crush the
tongue.
5. Install the coupler and
coupler handle onto the
tongue as shown. Then
tighten until the coupler
firmly grips the tongue. Don’t
over tighten and crush the
tongue.
NOTE: OVER TIGHTENING
WILL PREVENT THE
COUPLER LATCH FROM
FUNCTIONING PROPERLY.
2. Place the skid and chain
assembly under the tongue and
insert the bolt up through the skid
bolt hole on the bottom of the
tongue as shown.
3. Slip the nylon lock nut over the
bolt and hand tighten.
4. Check that the rear end of the
skid is still in its hole in the bottom
of the tongue. Fully tighten the bolt
and lock nut.
MALONE
R
technical@maloneautoracks.com
800-295-0042 ext. 215
19