800-295-0042 ext 206
15
MPG460XT
9. Connecting the side
lamps.
To control cutting between
two conductors without
damaging the wire or
yourself, press the wire
fl at against the frame then
squarely push the blade tip
between the conductors until it hits the frame.
Then with the knife tip still held fi rmly against
the frame, pull the wire gently away from the
frame so the blade cuts between the wires.
This way you don’t get cut and the risk of
cutting too much is greatly reduced.
Divide only about 1/2” of wire. Set the knife
aside.
10. Grasp either side of the cut with your fi nger-
nails and pull to separate 3” of wire as shown.
11. Press the brown wire into the quick connector
as shown. Then insert the wire from the side
marker light fully into the 2nd opening. Use
pliers to squeeze the conductor blade down and
through the insulation. The blade cuts through the
insulation and connects the wires inside. Flip the
cover to lock the connector. Repeat on the other
side again using the brown wire.
8. Route the wires thru the
mid cross member as shown
then secure the harness in
place using the frame clips
provided.
800-295-0042 ext.215
8. Use the clips provided to secure the wire to the inside of
the frame channel as shown.
7. With the wires routed all the way to the tail lights, firmly
grasp the wiring connections and plug-in matching colored
leads/wires. Repeat with all remaining lights.
NOTE: THESE UNUSED PLUGS ARE FOR AUXILIARY ACCESSORIES LIKE
THE MALONE MPG543 CHARGING UNIT AND/OR MPG539 FLOOD LIGHT
(NOT INCLUDED)
MPG539
MPG543
