Page
26
of
36
6.8. Editing programs – EdPr parameter.
The controller is by default equipped with 4 washing programs that can be edited, depending on the
user's needs. The remaining 4 places in the controller's memory are designed for creation of the
programs by the installer; they are empty (they do not contain any steps).
Each program can contain up to 100 steps (sequences), lasting from 1 sec. to 99 min. Each step is
assigned:
a)
status of 8 relay outputs – relay is active (red diodes marked 1-8 are on) or inactive (diode
assigned to a given relay is off),
b)
status of hydrostatic input – active (red diode marked H is on) or inactive (diode is off),
a)
the duration of the step (sequence); in the case of a step with a hydrostatic active, this is
a protection, in the event of a mechanical suspension of the hydrostatic.
Additionally, for the MCH-07T version, optionally you can assign to any of the steps:
a)
displaying the temperature;
b)
the temperature to which the heater is to be turned on;
c)
maintaining the set temperature for a specified time.
ATTENTION
If the clock function is set CL0=1 (indicating the dispensing of different detergents,
depending on the time of day), when setting in the appropriate step, activate relay 6.
Relay 7, dispensing detergent in the “afternoon”, will automatically turn itself on, changing with
relay 6.
ATTENTION
When editing a program or creating a new program, the necessary condition for creating a step
(sequence) is to determine its duration. Failure to specify a time of the step will skip this step
during program execution.
