P 1
5
/
18
Fig. D-03
Fig. D-04
W
iring diagram
1. AC motor unit
Brush holder
Brush holder
AC motor unit,
viewed from top
Field lead wire
to Controller
Field lead wire
to Controller
Field lead wire to Controller,
the longer one
Field lead wire to Controller,
the shorter one
Bind two Field lead wires
with
Band (cable tie)
at the exit
of the shorter Field lead wire.
Make sure that the longer
Field lead wire is tight
between
Band (cable tie)
and the exit of the wire.
Fix two Field lead wires
to each Brush holder
in these lead wire holders.
Fig. D-05
WRONG
The slack of
the pig tail wire
is out of place.
The pig tail wire is
not running right
due to wrong
connection of the
flag terminal to
Brush holder.
flag terminal
on pig tail wire
brush holding frame
CORRECT
pig tail wire of
Carbon brush
Install Carbon brush as shown below:
1 Place the slack of the pig tail wire of Carbon brush
between the dotted line and the brush holding frame
of Carbon brush.
2 Connect the flag terminal on the pig tail wire to
Brush holder so that the pig tail wire runs as shown
in the dotted circle.
