Makita LS1019L, Инструкция по эксплуатации

Страница: 14 / 28

14 ENGLISH
Hex wrench storage
When not in use, store the hex wrench as shown in the
figure to keep it from being lost.
1
► 1. Hex wrench
Removing and installing saw blade
WARNING:
Always be sure that the tool is
switched off and unplugged before installing or
removing the blade. Accidental start up of the tool
may result in serious personal injury.
WARNING:
Use only the Makita wrench provided
to install or remove the blade. Failure to use the wrench
may result in overtightening or insufficient tightening of the
hex socket bolt and serious personal injury.
Always lock the carriage with raised position when
removing and installing the blade. Pull the stopper pin
and rotate it 90° with the carriage raised.
1 2
3
► 1. Unlocked position 2. Locked position 3. Stopper
pin
Removing the blade
Loosen the hex bolt holding the center cover using the
hex wrench. Raise the blade guard and center cover.
3
1
2
► 1. Center cover 2. Hex wrench 3. Blade guard
Press the shaft lock to lock the spindle and use the hex
wrench to loosen the hex socket bolt. Then remove the
hex socket bolt, outer flange and blade.
1
2
4
5
3
► 1. Shaft lock 2. Hex wrench 3. Hex socket bolt (left-
handed) 4. Loosen 5. Tighten