Makita HR3541FC, Инструкция по эксплуатации

Страница: 5 / 52

5
ENGLISH
Explanation of general view
SPECIFICATIONS
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
* Net weight determined according to EPTA procedure (include side handle)
Intended use
ENE044-1
The tool is intended for hammer drilling in brick, concrete
and stone as well as for chiselling work.
Power supply
ENF002-1
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
SPECIFIC SAFETY RULES
GEB007-2
DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to rotary
hammer safety rules. If you use this tool unsafely or
incorrectly, you can suffer serious personal injury.
1. Wear ear protectors. Exposure to noise can cause
hearing loss.
2. Use auxiliary handles supplied with the tool. Loss
of control can cause personal injury.
3. Hold power tools by insulated gripping surfaces
when performing an operation where the cutting
tool may contact hidden wiring or its own cord.
Contact with a “live” wire will make exposed metal
parts of the tool “live” and shock the operator.
4. Wear a hard hat (safety helmet), safety glasses
and/or face shield. Ordinary eye or sun glasses
are NOT safety glasses. It is also highly
recommended that you wear a dust mask and
thickly padded gloves.
5. Be sure the bit is secured in place before
operation.
6. Under normal operation, the tool is designed to
produce vibration. The screws can come loose
easily, causing a breakdown or accident.
Check tightness of screws carefully before
operation.
7. In cold weather or when the tool has not been
used for a long time, let the tool warm up for a
while by operating it under no load. This will
loosen up the lubrication. Without proper warm-
up, hammering operation is difficult.
8. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
9. Hold the tool firmly with both hands.
10. Keep hands away from moving parts.
11. Do not leave the tool running. Operate the tool
only when hand-held.
12. Do not point the tool at any one in the area when
operating. The bit could fly out and injure
someone seriously.
13. Do not touch the bit or parts close to the bit
immediately after operation; they may be
extremely hot and could burn your skin.
14. Some material contains chemicals which may be
toxic. Take caution to prevent dust inhalation and
skin contact. Follow material supplier safety data.
1. Switch trigger
2. Lamp
3. Adjusting dial
4. Lock button
5. Pointer
6. Change lever
7. Power-ON indicator lamp (green)
8. Service indicator lamp (red)
9. Side grip
10. Bit shank
11. Bit grease
12. Bit
13. Chuck cover
14. Depth gauge
15. Clamp screw
16. Blow-out bulb
17. Screws
18. Connector
19. Crank cap cover
Model HR3540C HR3541FC
Capacities
Concrete
Tungsten-carbide tipped bit 35 mm
Core bit 90 mm
Steel 13 mm
Wood 32 mm
No load speed (min
-1
) 315 - 630
Blows per minute 1,650 - 3,300
Overall length 439 mm
*Net weight 5.2 kg 5.6 kg
Safety class /II