[3] DISASSEMBLY/ASSEMBLY
[3]-4. Torque limiter section (cont.)
DISASSEMBLING
ASSEMBLING
1. Set 1R369 to Tool holder complete.
Hook the 1R369 with 1R045, press down the 1R369 with
1R045 until Spiro lock washer appears.
2. Remove Spiro lock washer 30 by levering it up with
a thin slotted screwdriver from the spiral end along
the spiral direction.
3. Remove Flat washer 30 and Compression spring 31.
4. Remove Spur gear 51 and Driving flange.
R
epair
(5) The components of Torque limiter mechanism is secured with Spiro lock washer 30. Therefore, they can be
disassembled from Tool holder complete by removing Spiro lock washer 30. (
Fig. 10
)
Fig. 10
Spiro lock
washer 30
Spiro lock washer 30
removed by the step 2
Flat washer 30 on
Compression spring 31 side
Note
: Be careful not to lose four Steel balls 3
when Driving flange is removed from
Tool holder complete.
ﾊﾞ
5
Tool holder complete
Assemble by reversing the disassembly procedure.
Note
: Do not fail to set two Flat washers 30 in place. The one is placed between Compression spring 31 and Spiro lock
washer 31 as drawn in
Fig. 10
, the other is placed on Inner housing complete as drawn in
Fig. 9 of page 9
.
Be sure to apply Makita grease RB No. 00 according to the instruction in
Fig. 1 of
page 4
.
1R369
1R045
Compression
spring 31
Spur gear 51
Driving flange
5. Remove four Steel balls 3.
Steel ball 3
(4 pcs.)
thin slotted screwdriver
P 10/ 25
