[3] DISASSEMBLY/ASSEMBLY
[3]-1. Bit holder section
DISASSEMBLING
ASSEMBLING
(1) Disassemble Bit holder section as drawn in
Fig. 2
.
Tool holder section can be assembled by reversing the disassembly procedure. Refer to
Fig. 2
.
Note
: • Washer 16, Ring 21, Guide washer and Conical compression spring 21-29 are not reversible, and therefore,
be careful about the direction. See
Fig. 3
.
• Apply Makita grease No. RB No. 00 to two Steel balls 7.0 to prevent them from falling off.
Refer to
Fig. 1 of page 4
.
1. Remove Cap 35 with
a slotted screwdriver.
3. Remove Ring spring 15.
4. Remove Flat washer 17
and Chuck cover.
5. Remove two Steel balls 7
while pressing down Ring 21.
6. Ring 21, Guide washer and
Conical compression spring 21-29
are removed from Tool holder.
2. Remove Ring spring 14 using 1R003 with 1R212.
And then, remove Washer 16.
R
epair
1R003
1R212
Chuck cover
Fig. 2
Fig. 3
Cap 35
Slotted
screwdriver
Ring spring 14
Washer 16
Washer 16
Face the chamfered portions toward Cap 35.
Cap 35
1R003
1R212
Ring spring 15
Flat washer 17
Steel ball 7 (2pcs.)
Ring 21
Ring 21
Ring 21
Guide
washer
Guide washer
Conical compression
spring 21-29
Conical compression spring 21-29
Steel ball 7.0 (2 pcs.)
Face the projection toward
Conical compression spring 21-29.
Face the small diameter toward
Motor housing.
P 5/ 25
