Makita DUP361, Техническая информация

Страница: 25 / 29

P 25 / 29
<Supplementary explanation >
・
When controller was changed for repairing "ID is displayed with ----------"
When you know ID before the repair input the previous ID.
When do not know ID before the repair "ID input with 10BAB0X---". "- - -" of three columns of
down, input favorite numeric.
・
Be careful when you input ID as you have only one chance to input the ID. Even if I input wrong ID
you can use the machine and the "Makita tool" apps normally..
・
When you tap "Maintenance" on the screen, and the next screen is not displayed, confirm that ID has
been written correctly.
・
Letters and characters can be inputted by tapping “Note”.
・
When you tap a diagrammatic chart of the histogram (Load distribution) you can check the ratio of
load distribution in numeric. The ratio of load distribution is displayed in S/M/L/LL except the load
that is smaller than S.
<Supplementary explanation >
Error information Trouble-shooting
Trigger signal abnormality/ Check the connection of cord or sub controller
Battery low voltage/ Check battery or battery terminal
Blade Lock/ Check whether the cutter works or not.
Overheat (controller)/ Check the tightening of the cutter
Overheat (motor)/ Check the tightening of the cutter