Makita DUP361, Техническая информация

Страница: 17 / 29

P 17/ 29
W
iring diagram
Fig. D-3
RF unit has to be so put to Controller housing R
that its protruded portion faces to the bottom of the
Controller housing R.
Controller
Wiring in Controller Housing R
Put two pcs. of Choke coils between
Rib A and Controller.
RF unit
Rib A
Rib B
A A
3 pcs. of Connectors are put
between Rib A and Rib B.
Do not put Lead wires on this rib.
Put the Terminal to which the
following Lead wires are
connected, to this place.
* Lead wire (orange)
* Lead wire (blue)
* Lead wire (white)
Put Controller’s lead wires which are connected
to each connectors in this groove.
Put the Terminal to which
the following Lead wires
are connected, to this place.
* Lead wire (red)
* Lead wire (black)
* Lead wire (yellow)
Do not put Lead wires
on this Noise suppressor.
RF unit has to be so put
that the Lead wires can
be guide to the direction
illustrated below.
Put the following lead wires to this groove.
* Lead wires of RF unit
* Lead wires (red), (black), (yellow)
connected to Terminal
protruded portion
RF unit
Controller
housing R