Makita DST121, Инструкция по эксплуатации

Страница: 7 / 12

7 ENGLISH
Overload protection
When the tool/battery is operated in a manner that
causes it to draw an abnormally high current, the tool
automatically stops without any indication. In this sit-
uation, turn the tool off and stop the application that
caused the tool to become overloaded. Then turn the
tool on to restart.
Overheat protection
When the tool or battery is overheated, the tool stops
automatically and the lamp blinks. In this case, let the
tool and battery cool before turning the tool on again.
Overdischarge protection
This protection works when the remaining battery
capacity gets low. In this situation, remove the battery
from the tool and charge the battery.
Switch action
CAUTION:
Before installing the battery car-
tridge into the tool, always check to see that the
switch trigger actuates properly and returns to
the "OFF" position when released.
CAUTION:
When not operating the tool,
depress the trigger-lock button from B side to
lock the switch trigger in the OFF position.
To prevent the switch trigger from accidentally pulled,
the trigger-lock button is provided.
To pull the switch trigger, depress the trigger-lock button from A side.
After use, always press in the trigger-lock button from B side.
2
1
► 1. Trigger-lock button 2. Switch trigger
A
B
Adjusting the depth of driving
WARNING:
Always make the battery cartridge
and staples are removed before adjusting the depth
of driving. Unintentional firing may cause injury.
WARNING:
Do not put your fingers on the switch trig -
ger or the contact element. Unintentional firing may cause injury.
To adjust the depth of driving, adjust the height of the
depth guide by turning the adjuster.
The depth guide is can be adjusted in 5 steps. The
difference of one step is about 0.6 mm.
1 2
► 1. Adjuster 2. Depth guide
Lighting up the lamp
CAUTION:
Do not look in the light or see the
source of light directly.
Pull the switch trigger or actuate the contact element to light up the
lamp. The lamp keeps on lighting while pulling the switch trigger or
actuating the contact element. The lamp goes out approximately 10
seconds after releasing the switch trigger and the contact element.
1
► 1. Lamp
NOTE: Use a dry cloth to wipe the dirt off the lens of
the lamp. Be careful not to scratch the lens of lamp, or
it may lower the illumination.
NOTE: Even in the lamp lights up when the battery
power residual gets small, the stapler may not fire
staples. In this case, charge the battery cartridge.
NOTE: The lamp starts blinking if the stapler detects
an error during driving the staple. In this case, bring
the stapler to a Factory Service Center.