![background image](http://html.mh-extra.com/html/makita/dst121/dst121_instruction-manual_230449009.webp)
9 ENGLISH
Hook
CAUTION:
Do not hang the hook from the
waist belt.
Dropping the stapler, which is caused by
the hook accidentally coming out of place, may cause
unintentional firing and result in personal injuries.
The hook is convenient for temporarily hanging the tool.
This can be installed on either side of the tool.
To install the hook, insert it into a groove in the tool
housing on either side and then secure it with a screw.
To remove, loosen the screw and then take it out.
1
2
3
►
1.
Groove
2.
Hook
3.
Screw
OPERATION
Testing the safety system
WARNING:
Make sure all safety systems are
in working order before operation. Failure to do
so may cause personal injuries.
Test safety systems for possible fault before operation
as follows.
1.
Unload staples from the tool and keep the sub
magazine opened.
2.
Install the battery cartridge.
3.
Release the trigger lock.
4.
Only pull the switch trigger without touching the
contact element against the material.
5.
Only touch the contact element against the mate-
rial without pulling the switch trigger.
1
2
3
4
►
1.
Trigger-lock button
2.
Switch trigger
3.
Contact
element
4.
Sub magazine
If the tool operates in the case of 4 and 5 above, the
safety systems are faulty. Stop using the tool immedi-
ately and ask your local service center.
Driving staples
WARNING:
Continue to place the contact element
firmly on the material until the staple is driven com
-
pletely.
Unintentional firing may cause personal injuries.
WARNING:
Keep your face away from the tool
when operating the tool.
Failure to do so may cause injury.
You can operate the tool in either way of “single
sequential actuation” or “contact actuation”.
Single sequential actuation:
In this mode, you can drive one staple by one sequential operation.
1.
Place flat the contact element on the material.
2.
Hold the depth guide firmly against the material.
3.
Pull the switch trigger fully to drive the staples.
4.
Release your finger from the switch trigger before
moving the contact element from the material.
Contact actuation:
In this mode, you can drive staples sequentially.
1.
Pull the switch trigger.
2.
With the switch trigger pulled, place flat the con
-
tact element on the material to drive the staples.
3.
Move the tool to the next area and place flat the
contact element on the material again.
1
2
3
►
1.
Switch trigger
2.
Contact element
3.
Depth guide
Содержание DST121
Страница 1: ...INSTRUCTION MANUAL Cordless Stapler DST121 ENGLISH Original instructions Read before use ...
Страница 11: ...11 ...