MakeKit MD2 Dronekit, Руководство пользователя

Страница: 10 / 24

Motors and arms
4
Temporarily thread a small rubber ring onto the
motor plate (1). Click the engine plate with armrest
type a and b (2) and the landing legs (3). Finally,
tighten the rubber ring (4).
Repeat for all four arms.
1
3
2
2
Senter plate
2
3
4
5
1
6
Tools: Star puller
Parts:
1 top plate
4 nylon screws
8 spacers
4 nylon nuts
1 control card
1 power distribution board
Note the location of the top plate,
with the holder for the receiver
located on the left (1) and the
holder for the buzzer (2).
Also note the location of the
power distribution board, with the
battery cable facing south (3)
and the thinner battery
measuring cable facing north
(not shown)
Screw the 8 spacers above and
below the top plate (4), fasten
the power distribution board with
4 nuts (5), and finally the control
board with 4 screws (6).
1
2
3
Tools: 1.5mm Allen wrench
Parts: 4 engine plates, 4 engines, 4 propeller
protectors, 8 arm pieces (two variants), 4 landing legs,
16 pcs 10mm m2 screws, 4 o-rings
Screw in all four engine screws through the engine
plate (1), the propeller guard (2) into the engine (3).
NOTE! The screws must pass through both the
engine plate and the propeller guard!
x4
x4
10