MakeKit MD2 Dronekit, Руководство пользователя

Страница: 18 / 24

Oppstart
Turn on the radio transmitter.
Then connect the power by plugging in the drone battery in the yellow plug. The
control board then starts up and you should hear a beep in the buzzer.
• There should also be a beep every time you press a button.
• If the buzzer does not make a sound, tell the electrician to fix it.
• There may be error messages on the screen, which will disappear later.
• Check that the battery meter works. A full battery is about 12.6 volts. The
display should then say: “Battery: 12.6 volts”
ACC Calibration
We need to calibrate the accelerometer so that the control board knows
where the ground is.
Click “MENU” and “UP / DOWN” until you find this item. Follow the
instructions.
Setup radio receiver
This must be done together with the pilot.
Go to “Receiver Test”. Here it is important that both jacks on the
remote control correspond to the deflections on the screen. Each stick
represents two channels and is called Aileron (Roll), Elevator (Pitch),
Throttle and Rudder (Yaw). It is very important that the movement
detected on the screen is correct. For example, a right movement with
the right stick should result in the effect "Aileron: Right" on the screen.
Check that all four directions of flight are correctly registered by
the control card, both in cases of "left" and "right" as well as
"forward and" backward ".
The throttle should go from about 0 when it is down, to about 100
when it is at max. If this is reversed, you can use the reversal buttons:
Sticks vs screen
18
You should also make sure that the numbers are around 0 (+/-
5), when the sticks are in the neutral position, ie the throttle is in
the lower position, while the others bounce back to their starting
point. The trim buttons are used for this.