The Majestic Shower Company Limited
One North Place, Edinburgh Way, Harlow Essex
CM20 2SL England,
Tel44 (0) 8448 001 500
Fac44 (0) 1279 635 074
[email protected] www.majesticshowers.com
A
B
A
B
Glass
Return
Panel
10mm
Spacer
17
Loosely fix the faceplates to the glass-to-wall brackets through
the holes in the glass return panel; fully tighten the wall screws.
Ensure the glass return panel is plumb vertical, then fully tighten
the glass-to-wall bracket faceplates.
18
Align the profiles A and B across the front. Ensure the mitred end
is pushed into the corner, tape the profile into place and mark
its position.
Double check that inline profile A aligns with inline profile B.
Also check at this point that the gap between the profiles A + B
is equal to the width of the glass door panel + 9mm.
19
Insert the 10mm spacer into horizontal inline profile A, and use it
to align the second vertical wall profile. Push the mitred ends
together, and use a spirit level to ensure the wall profile is plumb
vertical.
Mark the screw holes; remove the vertical wall profile. Drill
4.5mm holes; insert Rawl plugs.
20
Reposition the vertical wall profile, and insert the top and bottom
screws to hold it place. Insert a rubber strip into horizontal inline
profile A. Using the suction glass lifters, lift glass inline panel A
into the profile.
Make sure inline panel A is plumb vertical and level with the
return panel; pack it up with 3” rubber strips if necessary, taking
note of their positions. Do not use more than three strips of
rubber under the panel.
