MP1900X Series Router Installation Manual
Power on and Run Router
copyright
2019 Maipu, all rights reserved
4-1
4
Power on and Run Router
4.1
Log into Router
When logging into the router for the first time, you can only log into the router via
Console port. This is the most basic mode of logging into the router and also the basis
of configuring other login modes.
4.1.1
Connect Console Cable
MP1900X router provides configuration serial port on the front panel. MP1900X-22-AC
supports EIA/TIA-232 and Micro USB 2.0 series ports, and MP1900X-12-AC supports
EIA/TIA-232 series ports. With these two interfaces, the user can use a PC (or laptop)
with RS-232 serial port (or USB interface) to configure the router.
To configure the router via the PC (or laptop), connect according to the following steps:
Step 1: Prepare one PC (or laptop). Confirm that the PC (or laptop) has the RS-232 serial
interface.
Step 2: After confirming that any one of the router or PC (or laptop) is powered off, connect the
RS-232 serial interface of the PC (or laptop) with the Console port of the router via the
configuration cable.
Step 3: The configuration cable (configured with the router) is one eight-core unshielded cable.
One side is the crimped RJ-45 plug, inserted to the Console port of the router; the other
side is one DB-9 (hole), inserted to the nine-core (pin) serial interface socket of the PC
(or laptop). The configuration cable is shown in Figure 4-1, and the connection diagram
is shown in Figure 4-2.
