CES-6000
|
9
|
en
Assembly
Fig. 3: Jack and main top assembly
14
Jack with pivot block (1)
15
Cap screw, 1/4”-20UNC, 1-1/2” long (3)
16
Flat washer, 1/4” (3)
17
Jack bracket, 1/4” thick (1)
18
Jack bracket spacer, 1/8” thick (4)
19
Nut, 1/4”-20UNC (3)
20
Retaining ring, 1-1/8” diameter (2)
21
Base pivot pin, 1-1/8” diameter (1)
22
Main top (1)
5.
Place item 14 on the pivot tube of the engine stand
base. Use items 17 and 18 to capture item 14. Item 17
will go over the top edges of item 14 to hold in place.
Item 18 is only used as a spacer; not all may be used.
6.
Item 14 should be secured and oriented to pivot tube
of engine stand as shown. Secure with items 15, 16,
and 19. Lay pivot tube on floor.
7.
Using a shop crane, lift item 22 and put onto engine
stand base (item 8), securing with items 20 and 21.
Fig. 4: Shaft assembly
23
Rotating shaft assembly (1)
24
Gardur bearing, 5-3/4” long (1)
25
Jack pivot mount (1)
26
Washer, 3” diameter (2)
27
Retaining ring, 3” diameter (2)
8.
Slide items 24 and 25 over the end of item 23.
9.
Slide items 26 and 27 to the end of item 25. Be sure
to secure item 27 in groove on item 23.
10.
Slide remaining item 27 over to the end of item 23,
securing it in the 2
nd
groove.
11.
Slide remaining item 26 to item 27 to complete shaft
subassembly.
