en
|
12
|
CES-6000
Maintenance and Inspection
9.
Maintenance and Inspection
WARNING
-
The engine stand must be inspected
according to the requirements of this section. Failure
to properly inspect the engine stand could lead to
severe injury or death. The engine stand must be
removed from service and inspected immediately if it
is subjected to an abnormal load or a shock load. If
any irregularities or problems are detected during an
inspection, the engine stand must be removed from
service immediately and repaired. Contact the
manufacturer using the contact information printed on
the back cover of this manual.
9.1
Inspection – before each use
Visual inspection of the engine stand must be made
before each use. The engine stand should be
immediately removed from service if any of the following
conditions are detected or observed:
Any part is cracked, chipped, bent, or shows signs of
excessive wear or any other type of damage.
The wheels and/or casters do not roll freely or the
axles appear bent or otherwise damaged.
Any abnormal condition or sign of damage that
suggests the engine stand will not work properly.
Check that all hardware is properly tightened and in
good condition.
Check that the engine mounting plates and mounting
hardware are not bent or stretched.
Verify that all warning and instructions decals are in
place and legible before the lift is put back in service.
If any decals are missing or illegible, contact the
manufacturer for replacements.
If any irregularities or problems are detected during an
inspection, the stand must be removed from service
immediately and repaired. Contact the manufacturer
using the contact information on the back cover of
this manual.
9.2
Maintenance instructions
WARNING
-
All inspection and maintenance procedures
must be performed after the jack has been removed
from service. Failure to do this may result in personal
injury and/or property damage.
All warning and capacity labels should be readable
and complete. Wash external surfaces of stand,
labels, and decals with a mild soap solution.
Lightly oil or grease any places where the paint has
worn off to prevent corrosion and lubricate
movement.
Grease front wheel axles.
