VZM 300
Trigger Menu
4.4
D1 2010BA0-GB03
4.4
Manual Start of Measurement
Prevents a premature start of the measurement when low trigger thresholds are used.
If manual start by hand trigger /<*> is set in the selector switches, the message "Begin
measurement with <*>/<HANDTR>" appears on the display after the start of the measurement
and the offset balance.
Press <*> or the hand trigger.
"$)+*"02/"*g
4)1%QJRNQR
Now the automatic trigger thresholds are active.
The measurement will be started once one of the START trigger thresholds has been
exceeded.
The measurement will be terminated after falling below one of the STOP trigger thresholds.
4.5
Start and Stop with Hand Trigger
This mode can be used for small decelerations and to avoid automatic test stop due to wheel
lockup.
If manual start by hand trigger /<*> is set in the selector switches, the measurement must be
started and terminated with the hand trigger. The message "Measurement Start/Stop with
<HANDTR>" appears on the display after the start of the measurement and the offset balance.
Press the hand trigger once to start the measurement,
press again to terminate it.
"0g1/1N1,-
4)1%QR
The automatic trigger thresholds and the settings of the Trigger Menu are deactivated.
If a key is pressed (e. g. <*>), the current measurement values are shown on the LCD, but the
recording of the measurement will not start until the hand trigger is actuated.
