w w w . m a g u r a . c o m
s e r v i c e @ m a g u r a . d e
Español Italiano Nederlands Français
English
Deutsch
1.
brake pad wear adjustment
HS 33
models
2.
brake pad wear adjustment
HS 11
MAGURA brakes do not need any special maintenance after correct installation.
Regular bleeding is absolutely not necessary, because the MAGURA Blood mineral oil
does not contract water like DOT brake liquid used in cars, on motorcycles and competi-
tors’ products.
brake pad wear adjustment as shown.
When
- the red TPA (HS 33 models) is turned all the way in
- the 4mm allen bolt is in flush with the lever blade (HS 11)
- the 2mm allen bolt is in flush with the barrel,
it is time to change the pads.
Before changing the pads you must always screw back the adjusting screws
to their start position!
3.
New (1) and worn (2) brake pad. When your brake pads are worn as shown it is
time to change them.
4.
To change the brake pads; open the quick release, remove the brake from the
cantistud, pull out the old pad and then just snap in a new one. After removing the wheel,
pull out the old pad and snap in a new one on the other side. That’s all!
10. Maintenance / brake pad change
1
2
13
