w w w . m a g u r a . c o m
s e r v i c e @ m a g u r a . d e
Español Italiano Nederlands Français
English
Deutsch
9
1.
For Manitou forks with “Reverse Arch Technology” (fork brace BEHIND the upper
legs) the standard booster does NOT fit. You need for this at any rate the “RAT-booster”
available separately as accessory.
2.
Replace the elbows by the threaded caps delivered with the RAT booster (
tigh-
tening torque 4Nm/34 in.lbs.
) Begin with the LEFT slave cylinder.
3.
Place the RAT booster as shown against the adaptor.
4.
Mount the unit onto the canti stud.
5. Tightening torque: 6 Nm/51 in.lbs.
6.
Proceed on the opposite side similarily and close the quick release as described
on page 8. The setup tricks mentioned on page 7 and 8 are valid with the RAT-booster,
too.
7. Correctly mounted RAT-booster.
The caps must fit the drills of the RAT booster.
IMPORTANT: the RAT booster can only be mounted with the adaptor position
shown here (MAGURA logo is on the RIGHT side!).
7. RAT Booster für Manitou Reverse Arch System
