MAGUIRE Weigh Scale Blender, Установка, эксплуатация и обслуживание

Страница: 50 / 141

M A G U I R E P R O D U C T S , I N C .
50
W E I G H S C A L E B L E N D E R

KEYPAD - PROGRAM MODE
In this mode, you may perform ALL of the functions available in MANUAL mode, plus additional functions that alter the logic with
which the controller operates. The PARA key operates in this mode. STAR FUNCTIONS are available by pressing the "*" key and
two numbers.
Just as with the MANUAL mode, you can enter this mode only when the controller is between cycles. The sensor must be covered
or the STOP switch must be in the "STOP - END OF CYCLE" position. In the MANUAL mode, no automatic dispensing will occur.
To enter this mode, press "*", then enter the correct password number. The correct password supplied with the unit is "22222". To
change this to another 5-digit number of your choice, see (*78). When in the PROGRAM mode, the letter "P" shows at the left end
of the display.
The following PROGRAM functions are available in the PROGRAM mode.
PARAMETERS - Press the PARA key to display the table of operating parameters that reside
in memory. There are 13 separate groups of parameters. The first group is the GENERAL
group and contains 49 GENERAL parameters. The other 12 groups are the COMPONENT
groups and contain 14 COMPONENT parameters each.
A FULL EXPLANATION of each PARAMETER can be found in the next section:
EXPLANATION of PARAMETERS.
The PARAMETER LIST looks like this:
General Component: 1 through 9, and A, B, and C
FLG 1TY 2TY 3TY CTY
MIX 1CS 2CS 3CS and so on up to: CCS
FCV 1AL 2AL 3AL CAL
DTI 1XT 2XT 3XT CXT
KDF 1SE 2SE 3SE CSE
WDF 1WT 2WT 3WT CWT
BER 1TI 2TI 3TI CTI
ROC 1MI 2MI 3MI CMI
ROV 1NC 2NC 3NC CNC
RHL 1RP 2RP 3RP CRP
FUL 1RD 2RD 3RD CRD
MAX 1LA 2LA 3LA CLA
TH 1PT 2PT 3PT CPT
TI
PRT
...and so on down to:
TRC
Press: PARA to ENTER the list at the TOP LEFT (FLG).
Press: PARA to move DOWN a list.
Press: * to move UP
Press: SET to move RIGHT (1st time, goes to 1TY)
Press: VIEW to move LEFT
Press: EXIT when finished.
In the COMPONENT lists:
The TOP parameter (TYPE) is ALWAYS accessible. The others are NOT accessible unless TYPE is set.
The First press of the PARA key will enter the GENERAL list at the top. Then the first press of the SET key will move to top of the
first component list. Press the PARA key to move down in any list. While in one COMPONENT list, press the SET key to jump to
the same relative position in the next list. This allows rapid scanning of like parameters in all component groups. To change a
displayed parameter, enter a new number in place of the old one. CE will cancel a number entry before the last digit is entered.
The purpose of each parameter is explained elsewhere in this manual. In any component list, if TYPE is set to "OFF"; (_TY= OFF);
other parameters in that list are not accessible. EXIT will exit the sequence at any time.