MAGUIRE Weigh Scale Blender, Установка, эксплуатация и обслуживание

Страница: 85 / 141

M A G U I R E P R O D U C T S , I N C .
85
W E I G H S C A L E B L E N D E R

Saving Parameters in the User Backup Settings
If the change
s you have made are PERMANENT, SAVE them in the “User Backup Settings”.
Sometimes during normal operation, electrical noise or RF (Radio Frequency) noise will corrupt the processor
memory. It may be necessary to do a CLEAR to fix this problem.
A "CLEAR" will clear all data from memory and replace it with information stored i
n the “User Backup Settings”.
So it is a good idea to have an exact copy of User Se
ttings stored in the “User Backup Settings” for just such an
emergency.
To copy and SAVE all syste
m parameter information into the “User Backup Settings”, the sequence of keystrokes is
as follows:
Save Parameters Keypad Sequence:
Press Display will say: ENTER PASSWORD
Press Display will say: PROGRAM
Press Display will say: INSTRUCTION [ __ ]
Press Display will say: SAVE USER SETTINGS
Wait: when done, Display will say: PROGRAM
Press
Display will say: WAITING
With this done, all correct Parameters may be restored from EEPROM to RAM at any time by doing a CLEAR.
If software related problems should develop later, RETRIEVE this correct copy of the parameters from the EEPROM.
This clears corrupted data from RAM and corrects most software problems.
To Retrieve:
Retrieve Parameters (CLEAR) from User Backup Settings - Keypad Sequence:
Switch Power Off to the Controller
Hold
Hold the “CE” Key down
Switch Power on to the Controller
Release
The “CE” Key
Display will say: *** CLEAR ***
If you do not see
CLEAR on the display, do it again.