MAGUIRE Weigh Scale Blender, Руководство по эксплуатации и техническому обслуживанию

Страница: 42 / 81

42
KEYPAD - PROGRAM MODE
In this mode, you may perform ALL of the functions available in MANUAL mode, plus additional functions that alter the logic
with which the controller operates. The PARA key operates in this mode. STAR FUNCTIONS are available by pressing the
"*" key and two numbers.
Just as with the MANUAL mode, you can enter this mode only when the controller is between cycles. The sensor must be
covered or the STOP switch must be in the "STOP - END OF CYCLE" position. In the MANUAL mode, no automatic
dispensing will occur.
To enter this mode, press "*", then enter the correct password number. The correct password supplied with the unit is
"22222". To change this to another 5-digit number of your choice, see (*78). When in the PROGRAM mode, the letter "P"
shows at the left end of the display.
The following PROGRAM functions are available in the PROGRAM mode.
PARAMETERS: Press the PARA key to display the table of operating parameters that reside in memory. There are 13
separate groups of parameters. The first group is the GENERAL group and contains 20 GENERAL parameters. The other
12 groups are the COMPONENT groups and contain 13 COMPONENT parameters each.
A FULL EXPLANATION of each PARAMETER can be found in the next section: EXPLANATION of PARAMETERS.