Magtek MT-95, Инструкция по установке и эксплуатации

Страница: 20 / 54

MT-95 RS-232 HiCo/LoCo Encoder/Reader
12
If the card is removed before the encode operation, the unit will send an error message
(M) indicating that the card has been moved and the operation has been aborted.
This mode is selected from the PC by sending the “/S” command.
8. When Enter is pressed, the Setup menu will be shown:
Select option to change Esc=exit
T)racks S)erial E)ncode M)ode C)ard Time
Type C to define the card timeout. The following menu will be shown:
Type in Encode Timeout: [Ins] Enter=done
000 Seconds (Max=255, 0=Disable Timeout)
If the timeout value is zero, an encode function will never time out. If any other value
(from 1 to 255) is selected, an encode operation will time out after the specified number
of seconds. Additionally, if the value is non-zero, the encode operation will be aborted if
a card is inserted and removed without completing the encode. If the timeout is set to
zero (000), a card may be inserted and removed or an encode may be attempted for an
unlimited number of attempts until successful.
After entering the desired value, press Enter . If you do not wish to change the value,
press Esc .
9.
From the Setup Menu, there is one hidden command. When the Setup Menu appears,
press
6 and the following appears:
Select read status Enter=done
S)how status D)on’t show status
The default is
D)on’t show status
. If
D
is selected and an error occurs, a normal
display will be similar to the following:
**Did not encode properly. Try again.**
--> Slide card right when ready -->
If
S
is selected and an error occurs during encoding, a display similar to the following
will appear: