Magnum MIG 208 Alu Synergy, Руководство пользователя

Страница: 17 / 24

17
7. Push wire in the groove by tightening the drive rollers 7. Push wire in the groove by tightening the drive rollers
pressure.
8. Remove gas nozzle and contact tip, unscrew. 8. Remove gas nozzle and contact tip, unscrew.
9. Switch on the device. 9. Switch on the device.
10. Handle develop so that it is in a straight line, then 10. Handle develop so that it is in a straight line, then
press the button on the handle until the emergence of a wire in the outlet
(approx. 20 mm), release the button.
11. Screw the contact tip, replace the gas nozzle. 11. Screw the contact tip, replace the gas nozzle.
12. Adjust the pressing force by rotation of the feed roller, 12. Adjust the pressing force by rotation of the feed roller,
pressing the knob. Too little downforce, cause
will slip to the drive roller. Too much contact force, increases the resistance of administration and the
deformation of the wire, which in turn can cause the cutting.
7.4 Connection of protective gas.
1. The cylinder with a suitable protective gas should be set to a semi-automatic shelf (if present) or the wall 1. The cylinder with a suitable protective gas should be set to a semi-automatic shelf (if present) or the wall
and prevent it from tipping over, securing it to the support by means of a chain.
2. Remove the protective cap and the second valve unscrew the bottle to remove any impurities. 2. Remove the protective cap and the second valve unscrew the bottle to remove any impurities.
3. Install the regulator so that the gauges were in the upright position. 3. Install the regulator so that the gauges were in the upright position.
4. Combine with semi-cylinder (outlet of the regulator nozzle clip) corresponding hose. Connector for 4. Combine with semi-cylinder (outlet of the regulator nozzle clip) corresponding hose. Connector for
connecting the protective gas is placed at the rear.
5. Unscrew the regulator valve just prior to welding. After completion of welding, spin the cylinder valve should 5. Unscrew the regulator valve just prior to welding. After completion of welding, spin the cylinder valve should
be.
6.
Avoid welding in the open air or within - a blast of air can disrupt the flow of the shielding gas and
6.
Avoid welding in the open air or within - a blast of air can disrupt the flow of the shielding gas and
liquid metal strip protection.
7.5 welding parameters for MIG / MAG
The basic parameters of the MIG / MAG: welding current and wire feed speed of the
electrode. Increase welding current increases penetration (penetration depth) and elongation of the
arc. Increasing the speed of a wire electrode causes the handle is biased upwardly from the parts to
be welded. This is due to too small a welding current. When the wire feed speed of the electrode is
too small or the welding current is too high at the end of the electrode wire formed large droplets.
Excessive spatter prove too low welding current or too high feeding speed of the electrode wire.
When welding positions and pułapowych wall, you can reduce the welding current, the performance
of joint filler to achieve a smooth face, you can increase the welding current.